Control of crankshaft finish by scattering technique

Anno: 2001

Autori: Fontani D., Francini F., Longobardi G., Sansoni P.

Affiliazione autori: CEO Centro di Eccellenza Optronica, Largo E. Fermi 6, 50125 Firenze, Italy
Istituto Nazionale di Ottica, Largo E. Fermi 6, 50125 Firenze, Italy;

Abstract: The paper describes a new sensor dedicated to measure and check the surface quality of mechanical products. The results were obtained comparing the light scattered from two different ranges of angles by means of 16 photodiodes. The device is designed for obtaining valid data from curved surfaces as that of a crankshaft. Experimental measurements show that the ratio between scattered and reflected light intensity increases with the surface roughness. This device was developed for the off-tolerance detection of mechanical pieces in industrial production. Results of surface quality on crankshaft supplied by Renault were carried out. (C) 2001 Elsevier Science Ltd. All rights reserved.

Giornale/Rivista: OPTICS AND LASERS IN ENGINEERING

Volume: 35 (6)      Da Pagina: 387  A: 396

Maggiori informazioni: This work was partially supported by the European Community within a European Project BRPR-CT97 0372 named “SMARTMEC”. We thank Mr. Marco Innocenti (CEO) for his contribution to the graphics.
Parole chiavi: Crankshafts; Light reflection; Optical variables measurement; Photodiodes; Surface roughness, Off-tolerance detection, Light scattering
DOI: 10.1016/S0143-8166(01)00021-5

Citazioni: 6
dati da “WEB OF SCIENCE” (of Thomson Reuters) aggiornati al: 2024-04-14
Riferimenti tratti da Isi Web of Knowledge: (solo abbonati)
Link per visualizzare la scheda su IsiWeb: Clicca qui
Link per visualizzare la citazioni su IsiWeb: Clicca qui